- Joined
- May 6, 2019
- Messages
- 12,871
- Points
- 113
Early benchmarks for some of Intel's upcoming "Raptor Lake" processors continue to surface, and the results are lovely.
Go to post
Go to post
Lets me honest overall we don't care about Watts. I know I'm putting words in your mouth but I don't think anyone that's an enthusiast does. If you're building an HTPC for your entertainment center different story but you're more worried about breathing and heat dissipation than power consumption unless you're tripping breakers.Raptor Lake will be competing with Zen 4, not Zen 3. E cores don't interest me, but the single-thread gains look good. How many $ and how many watts, though?
That all kinda goes hand in hand....If you're building an HTPC for your entertainment center different story but you're more worried about breathing and heat dissipation than power consumption
I take the limits off my 12700k and 3080 12GB FTW, and I can pull 850W+ at the wall during stress testing.Lets me honest overall we don't care about Watts. I know I'm putting words in your mouth but I don't think anyone that's an enthusiast does. If you're building an HTPC for your entertainment center different story but you're more worried about breathing and heat dissipation than power consumption unless you're tripping breakers.
I care, especially at idle and low utilization states. What I'm not overly concerned about is peak power usage (on a desktop), except to the extent that it demands exotic cooling solutions or imposes other undesirable build restrictions.Lets me honest overall we don't care about Watts. I know I'm putting words in your mouth but I don't think anyone that's an enthusiast does. If you're building an HTPC for your entertainment center different story but you're more worried about breathing and heat dissipation than power consumption unless you're tripping breakers.
Right but that is during stress testing. Outside of the occasional stress test (for the non reviewers amongst us) when is power demand that great?I take the limits off my 12700k and 3080 12GB FTW, and I can pull 850W+ at the wall during stress testing.
Main point is that, as you note afterward, it is poised to start becoming an issue - I gave my personal system as an example, and it isn't comprised of top-end parts. Next-gen top-end parts look to be able to gobble down even more power at the extremes.Right but that is during stress testing. Outside of the occasional stress test (for the non reviewers amongst us) when is power demand that great?
I couldn't tell you what the efficiency of my current 1000W PSU is - it was purchased last year when affordable 1000W units of known quality were rarer and I simply needed the power output as 850W was just not enough!I suppose I'm in the minority with a power supply of higher efficiency rating. But as power draw creeps up having a 1200 watt 80+ gold or Bronze will be an issue compared to Titanium or Platinum. We will need the efficiency to run stable systems that CAN do sustained benchmarking as an example and not flip power breakers.
It's worth looking...and on your next build I personally would recommend nothing less than platinum rated... I bought platinum this go around because I THOUGHT that was the top tier. If I had known titanium was an option I would have gone with that and paid the extra 50 bucks or so. Not that you can get one when I was looking. Platinum was the best I could find.I couldn't tell you what the efficiency of my current 1000W PSU is - it was purchased last year when affordable 1000W units of known quality were rarer and I simply needed the power output as 850W was just not enough!
I also now consider 1000W to be the minimum for higher-end builds. I'm personally waiting until we get some 1300W+ units with the new 16-pin GPU connector.
Same here, but I did know about the Titanium and felt it was a bit overkill at the time. If I had to do it over I would have went with with the Titanium though.It's worth looking...and on your next build I personally would recommend nothing less than platinum rated... I bought platinum this go around because I THOUGHT that was the top tier. If I had known titanium was an option I would have gone with that and paid the extra 50 bucks or so.
That's with eight P cores and sixteen E cores - versus sixteen Zen 3 cores.Really. If it's only up to 10% faster than AMD's top tier CPU right now AMD doesn't have much to improve upon to best that. That's not a big lead. lol
Doesn't matter, since the two are not comparable in that sense. What is comparable is overall performance. And 10% is not a wide gap to bridge.That's with eight P cores and sixteen E cores - versus sixteen Zen 3 cores.
That's with eight P cores and sixteen E cores - versus sixteen Zen 3 cores.
Agreed, and it really does depend on what you're comparing. Intel's P-cores are certainly stronger than Zen 3 cores, and also clock higher, so there's your single-thread advantage. But as we've seen with say the 5800X3D that is clocked lower than the standard 5800X, that matters less and less as time goes on, even for gaming.Doesn't matter, since the two are not comparable in that sense. What is comparable is overall performance. And 10% is not a wide gap to bridge.
The i5's will be pretty significantly cut down, and the i7's somewhat too. Price / performance comparisons will certainly be interesting - and I really don't know where the E-cores will move the needle. They do work and are fairly impressive on their own, almost as potent as Zen 2 cores.Sure but what are they going to charge for the new 8core16t + 16ecore i5? At $300 its not too shabby compared to the 16 core's current (likely soon to be lower) $550. If the e-cores work with the programs you need the threads for.
In my main system with dual 360mm radiators and a 1000W PSU I'm less concerned. The only Intel system I have right now is a mini ITX with a 12400, Thermalright AXP-90 X53, and 850W. The heatsink is rated for 150W. I know a 13900 is out of the question, but will I have the option of a 13600?Lets me honest overall we don't care about Watts. I know I'm putting words in your mouth but I don't think anyone that's an enthusiast does. If you're building an HTPC for your entertainment center different story but you're more worried about breathing and heat dissipation than power consumption unless you're tripping breakers.
Yes, though specifically how you limit the CPU to a particular wattage as opposed to having it thermally throttle will depend on the board. Most Z-series boards tend to be pretty good about setting a wattage target or wattage range, in my experience.The heatsink is rated for 150W. I know a 13900 is out of the question, but will I have the option of a 13600?