Jonsbo Launches M.2 2280 SSD Active Cooler with Dual Heat Pipes and a 10,000 RPM Fan

[Tsing]

Jonsbo has begun advertising the M.2-7, a new cooling solution for M.2 2280 NVMe SSDs that features not only a pair of heatpipes, but also a fan for active cooling that's capable of speeds ranging from 3,000 RPM to 10,000 RPM.

See full article...

 

[Brian_B]

That’s …. is there a word that means impressive but stupid at the same time?

 

[Endgame]

Not even 40mm at 10k? Yeah, that fans dead in 6 months

 

[Niner51]

Looks like it's ready to send the NVME out the back of the case with the look of that design.

 

[Burticus]

10k rpm fan? Nope!

 

[Burticus]

That’s …. is there a word that means impressive but stupid at the same time?

https://www.thelocal.de/20181015/german-word-of-the-day-die-schnapsidee

 

[DrezKill]

Looks like it's ready to send the NVME out the back of the case with the look of that design.

Sure you can measure SSD NAND access times, latency, and data write/read rates, but sometimes the speed of an SSD is measured in miles per hour.

 

[Grimlakin]

Looks like it's ready to send the NVME out the back of the case with the look of that design.

You know it's bad when you have to use a Torq wrench to tighten your M.2 screw.

 

[Endgame]

In all honesty, it’s max 1.5 CFM. That puppy isn’t going anywhere compared to the 10k rpm whine.

 

[Grimlakin]

In all honesty, it’s max 1.5 CFM. That puppy isn’t going anywhere compared to the 10k rpm whine.

Article lists the max as 1.37 CFM. But when you push that through a pinhole....

 

[Zarathustra]

10krpm?